You are here:

STAGE6 TOOLS

SPECIAL PRODUCTS FOR EVERY APPLICATION

STAGE6 R/T

MOUNTING TOOLS

Holding tool clutch bell, for the R/T CNC clutch bells from Stage6 or similar bells. Two recesses in the cooling ring provide the necessary grip to block the bell with the Stage6 Clutch Bell Tool and loosen the screw without an impact wrench.

Oil seal mounting aid Stage6 Piaggio / Gilera. Useful tool for all owners of Piaggio LC 50 – 180cc engines. Use this installation tool to insert the water pump oil seal in the correct position. Incorrectly seated oil seals do not seal properly and significantly increase wear. The result is premature defects and even leakage.

Händler Finden

STAGE6

MEASURING TOOLS

Degree wheel Stage6 black incl. installation material – precision tool to accurately measure the cylinder port timing in 2-stroke engines. The grade wheel is anodized black and protected against gasoline and other additives. The spacer allows the disc to be mounted on all 50cc engines, the pointer is simply screwed to the cylinder stud.

Stage6 oil measuring cup for 2-stroke mixture. On racing scooters, most people remove the oil pump and the mixture has to be prepared in advance. An oil measuring cup is an important companion for self-mixers, with all the important and, above all, standardized scales for precise measuring of the 2-stroke oil.

The measuring cup has 3 scales, each for a different mixing ratio (max. 12 liters of fuel).

The measuring cup can be closed and be used as an oil storage container. The lettering is resistant to oil and fuel, and an extra sealing ring means you don’t have to worry about soiling your helmet compartment.

Händler Finden

STAGE6

TESTING TOOLS

Check the tightness of your engine with this handy Stage6 leak test kit. After assembling the engine, you can check whether the engine is completely airtight. Detailed instructions are included.

The kit includes 4x intake plugs 25mm / 28mm / 35mm / 39mm and 4x valves, covering virtually all carburetor sizes / intake manifold sizes.

Dummy plug CNC machined aluminum from Stage6 Orange with Stage6 logo on both sides. This spark plug plug can be used instead of the spark plug to close the spark plug hole.

Due to the O-ring seal, this can also be used to test for pressure loss which is especially interesting for newly installed engines to check if the engine is sealing properly.

The plug can be left in the engine until use and reliably prevents dirt and other foreign bodies getting into the engine during transport or storage, without the risk of damaging the spark plug or the spark plug thread.

Händler Finden